-all_drives

Forces R-Linux to show all partitions in the system. Normally R-Linux shows only local disks in the system. Some storage devices may pretend that they are not local disks.

-debug

Includes additional debug information. When this switch is used, an additional command Create FS Snapshot on the context menu appears for an object with a file system. An FS Snapshot contains system data for the file system only (file descriptions without file contents). If a problem appears, this snapshot can be sent to R-Linux technical support to identify the problem. This switch greatly slows R-Linux . You may also turn this mode on by selecting Debug Mode on the Tools menu

-flush

Flushes the log file after each write to log operations. This switch is helpful when R-Linux locks and its log file remains in memory cache unwritten to a disk. This switch greatly slows R-Linux .

-log <filename>

Started with this switch, R-Linux writes its log into the specified file. If R-Linux locks and its log file remains in memory cache unwritten to a disk, use the -flush switch.

-mem <size in MB>

Sets memory usage limit in MB for R-Linux to reconstruct the file tree. When it exceeds the limit, a Too many files... message appears. You may temporally stop file listing and browse through found files. Then you can resume file listing. You also may skip this file section and continue file listing. Example: -mem 400 - sets the limit to 400 MB.

-no_ide_ext

Turns off the inquiry about extended information on HDDs in Wind9x/ME. This switch may be helpful if R-Linux returns information about HDDs incorrectly (detects HDD geometry incorrectly).

-no_int13

Turns off the disc access through Int13 in Wind9x/ME. This switch may be helpful if the system operates incorrectly (detects HDD geometry incorrectly or lock the system).

-no_ios

Turns off the Wind9x/ME protected-mode I/O system. This switch may be helpful if this system operates incorrectly (detects HDD geometry incorrectly or lock the system).

-reset

R-Linux resets an HDD controller each time it reads a bad sector. This switch may be helpful if the controller locks after it attempts to read a bad sector, or returns incorrect data.

-safe

Disables automatic partition search on a hard drive, file system recognition on partitions, and other potentially problematic operations. In this mode, it is necessary to use Find partition command from the hard drive context menu to manually find a partition.